Sump pumps · flood prep

Basement flood-prep kit: what to have before the water comes

A sump pump and backup are the first line of defense. A flood-prep kit is what you reach for when water gets in anyway — or when the power goes out during a storm. Here is a short plan and a kit list that fits on one shelf.

As an Amazon Associate I earn from qualifying purchases. Product links below go to Amazon.

Bottom line Make the plan first: know where your electrical panel and water shutoff are, test the sump and backup, and put alarms where water shows up first. Then stock a wet/dry vac, a small utility pump, a dehumidifier, and a few water barriers. Never walk into standing water if outlets or appliances could be energized. If water comes in more than once, call a waterproofing pro — a kit does not fix the cause.

The plan (before the storm)

  1. Know your shutoffs. Label the main electrical panel and the basement circuits, and know where the main water shutoff is.
  2. Test the sump system. Run the bucket test on the primary and the backup — see how to test a sump pump.
  3. Check the backup power. Charge or replace batteries — see backup pump batteries and battery-backup sump pumps. On city water, a water-powered backup is another option.
  4. Add early warning. A high-water alarm in the pit and leak sensors at low spots — see alarms and Wi-Fi monitors.
  5. Clear the discharge. Make sure the outlet is open and carries water away from the foundation — see discharge routing.
  6. Get things off the floor. Shelves and lidded plastic bins for anything you cannot replace.
  7. Document. Take photos of the basement and contents for insurance before anything happens.

The kit

ItemWhat it is forWhat to look for
Wet/dry vacShallow water, wet carpet edges, cleaning out the pitLarger tank and a drain port so you are not lifting a full tank; a GFCI-protected outlet
Utility (transfer) pumpInches of standing water a vac cannot keep up withGarden-hose outlet, long enough cord, a hose to route water outside
DehumidifierDrying the space after water and keeping humidity downBasement-rated with a built-in pump or gravity drain so it runs without emptying a bucket
Water barriersSlowing water at a walkout door, window well, or garage entryWater-activated absorbent bags or reusable barriers — short-term help, not a seal
High-water alarmWarning before water reaches the floorBattery-powered so it works in an outage
Headlamp, rubber boots, glovesWorking safely in the dark and wetWaterproof light, spare batteries

When water gets in

  1. Stay out of standing water if it could reach outlets, cords, or appliances. If you cannot reach the panel from a dry spot, call the utility or a licensed electrician.
  2. Never run a generator or gas pump indoors, in the garage, or near windows — carbon monoxide kills.
  3. Find the source: a failed sump, a frozen or blocked discharge, a window well, a plumbing leak, or groundwater through the walls.
  4. Remove water with the utility pump, then the wet/dry vac.
  5. Dry fast. Run fans and the dehumidifier and move wet items out. The EPA advises drying water-damaged areas within 24–48 hours to help prevent mold.
  6. Treat sewage backup as hazardous. If water came from a floor drain or sewer, call a cleanup pro.
  7. Photograph damage and call your insurer before throwing things away.

When to call a pro

Getting help

Start with a waterproofing pro for chronic water and a licensed plumber for the sump system. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates with general pump questions.

Related across the site

Sources

More in this section