Water softeners · drinking water
Softener plus under-sink RO: why pair them
A water softener and a reverse osmosis (RO) system do different jobs. The softener protects the whole house from scale; the RO polishes a small amount of water at one tap for drinking and cooking. Many homes with hard water end up with both — here is why, and how they fit together.
What each one does
| Water softener (ion exchange) | Under-sink RO | |
|---|---|---|
| Where | Whole house, at the main line | One tap, usually the kitchen sink |
| Main job | Removes hardness to stop scale in pipes, heaters, and fixtures | Reduces dissolved solids for drinking and cooking water |
| Adds anything? | Yes — sodium (or potassium if you use KCl) | Some systems add a remineralization stage; check the listing |
| Wastewater | Brine and rinse water during regeneration | Reject water to the drain while making water |
| Upkeep | Salt, occasional cleaning — see how much salt | Prefilter and postfilter changes; membrane on the maker’s schedule |
Salt-free “softeners” are conditioners or scale-control media, not ion exchange. They do not remove hardness, so they do not give an RO the same protection — see salt-based vs salt-free.
Why pair them
- Membrane life: hardness scales RO membranes. Softened feed water reduces that load, which is why many RO makers recommend pre-softening on hard water — check your system’s feed-water limits.
- Sodium at the drinking tap: softened water carries added sodium. An RO at the kitchen tap reduces it. If anyone in the home is on a sodium-restricted diet, ask their doctor and consider a hard-water bypass or RO at the drinking tap.
- Taste and dissolved solids: a softener does not lower total dissolved solids; an RO does.
- Not a substitute for testing: neither one is a cure-all. Well owners should test for bacteria, nitrate, arsenic, and other local concerns — see well water testing — and match treatment to the results.
Setup order
- Sediment filter (if needed) — see sediment prefilters.
- Iron or other pre-treatment, if your water test calls for it.
- Water softener on the main line.
- Under-sink RO on the softened cold line at the kitchen sink, with its own faucet and a drain saddle or air-gap faucet as local code requires.
Some homeowners run the RO on an unsoftened cold line to avoid sodium entirely. That works, but expect more frequent prefilter and membrane changes on hard water. Follow the RO maker’s feed-water limits either way.
Checking that both are working
- Softener: test hardness at a softened tap — see hardness test kits and is my softener working?
- RO: compare total dissolved solids (TDS) at the RO faucet with the feed water. A rising RO reading over time usually means filters or the membrane are due. A TDS pen is not a hardness test.
When to call a pro
- Drilling the countertop or sink for an RO faucet, adding a supply tee, or tying into the drain — a licensed plumber.
- Iron, odor, bacteria, or any health-related contaminant — a water-treatment pro to design treatment after a certified lab test.
Start with a licensed plumber for the drain and supply connections and a water-treatment pro for test-based design. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates.
Related across the site
- Well water testing — test before you pick treatment
- Supply lines and shutoff valves — the under-sink connections an RO taps into
Sources
- RO system manufacturer installation manuals — feed-water limits, drain connection, and filter schedules.
- NSF/ANSI standards for drinking water treatment units (including NSF/ANSI 58 for reverse osmosis) — check a system’s listed certifications.
- Model plumbing codes (IPC and UPC) — drain connections and air gaps; check your local adopted code.