Sump pumps · two-pump systems
Dual-pump sump pits and alternating controllers
Some pits hold two pumps: one to do the daily work and a second to take over if the first fails or the water rises faster than one pump can keep up. A controller decides which pump runs and when. This page explains the vocabulary so you can talk with the installer; it is not a wiring guide.
Bottom line
Two pumps are redundancy for equipment failure and heavy inflow, not a substitute for power. If the grid is down both electric pumps stop — see battery backup. Have a licensed plumber and, for wiring, a licensed electrician design and install the system.
Common ways two pumps are arranged
- Alternating: a controller swaps the lead pump each cycle so the wear is shared. If the water keeps rising, the second pump joins in.
- Lead/lag (fixed): pump one always runs first; pump two switches on only at a higher level or if the first fails.
- Primary plus backup: a second pump, sometimes battery or water-powered, set to start at a higher level — see water-powered backups.
What an alternator controller does
| Piece | Role | Pro note |
|---|---|---|
| Alternating relay or duplex control panel | Swaps lead and lag pumps and passes power to the selected pump | Sized to the pumps’ motor current; installed by a licensed electrician |
| Level floats or sensors | Signal when to start the lead pump, start the lag pump, and raise the alarm | Float tangling is a frequent trouble spot — see float switches |
| High-water alarm | Signals if the level passes the lag pump’s on point | Test it; see alarms and Wi-Fi monitors |
| Check valves and discharge | Each pump needs its own check valve before the discharge pipes join | See check valves and discharge sizing |
Pit and discharge considerations
- Two pumps need a pit large enough that they do not crowd each other or the floats — see liners and lids.
- Each pump should have its own discharge line or a properly designed manifold with a check valve on each leg.
- Both pumps may share one outdoor discharge, which can still freeze or clog — see discharge freeze protection.
- Running two pumps on one circuit can overload it. Circuit layout and GFCI/AFCI rules are for the electrician and local code.
Careful claims
- A two-pump pit is not a guarantee against flooding.
- Alternation reduces uneven wear; it does not remove the need to test both pumps — see the test checklist.
- This page gives no wiring diagrams. Controller wiring varies by model and code.
When to call a pro
- Adding a second pump or a controller — licensed plumber and electrician.
- Both pumps run constantly, or the alarm sounds — plumber right away, and check for power or discharge problems.
- Pit sizing, a new discharge route, or a sewage ejector/effluent pit — plumber; sump pumps are not for sewage.
Getting help
Start with a licensed plumber (and electrician for the controller) to design a dual-pump pit. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates.
Related across the site
Sources
- Sump pump and controller manufacturer manuals for duplex wiring and float setup.
- Local plumbing and electrical codes for discharge and circuit requirements.
- Licensed plumber and electrician guidance for the specific pit.