Well pumps · system parts

Well check valves and torque arrestors

Two small parts in a submersible well do a lot of work. Check valves hold the water column in the pipe when the pump stops. A torque arrestor keeps the pump centered and steady when it starts. Here is what each one does, what failure looks like, and why replacing them is a job for a licensed well contractor.

As an Amazon Associate I earn from qualifying purchases. Product links below go to Amazon.

Bottom line A leaking check valve can cause short cycling, pressure that bleeds down overnight, and water hammer. A missing or worn torque arrestor lets the pump twist and rub the casing on every start. Both sit down the well, so checking or replacing them means pulling the pump — hire a licensed well contractor. Follow the pump maker’s manual for how many check valves to use and where.

What a check valve does

When a submersible pump shuts off, the water in the drop pipe wants to fall back down the well. A check valve lets water flow up and closes when flow stops, so the pipe stays full and the pressure tank does not drain back through the pump.

Avoid drilling a weep hole in a check valve or adding valves above ground just to stop a drain-back symptom. That can hide a leak and create other problems. Find the cause instead.

Signs of a check valve problem

SymptomCould be the check valve if…Rule out first
Pump kicks on briefly with no water in usePressure bleeds back down the pipeRunning toilets and other leaks — see short cycling
Pressure gauge drops slowly overnightNo fixture or leak explains the dropLeaks in the house and yard line; watch the pressure gauge
Loud bang or hammer when the pump starts or stopsThe column drains and slams, or a valve closes hardLoose pipe straps; tank precharge
Spitting air at faucets after the pump has been offThe drop pipe drains back between cyclesLow water level in the well — see low water pressure

What a torque arrestor does

When a submersible motor starts, it twists against the drop pipe. On plastic or flexible pipe that twist can swing the pump into the well casing, scuffing the pump, chafing the wire, and wearing the pipe. A torque arrestor is a rubber or stainless collar installed just above the pump that centers it in the casing and absorbs that kick.

Why this is contractor work

When to call a pro

Getting help

Start with a licensed well contractor for anything down the well. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 and can talk through Grundfos well pumps — contact R.E. Merrill & Associates.

Related across the site

Sources

More in this section