Fixtures · faucets
Bathroom faucet cartridges: identify and replace
A drip from the spout, a handle that is stiff, or hot and cold that will not mix right usually points to the cartridge — the valve inside the faucet body. Getting the exact replacement is most of the job.
Bottom line
Identify the faucet brand and model first (look under the sink, at the original paperwork, or on the maker’s website), then buy the matching cartridge — genuine parts from the faucet maker are the safest fit. Shut off the supply at the angle stops before you start. If the stops do not hold, the faucet body is corroded, or the faucet is inside a wall valve, call a licensed plumber.
Common cartridge types
| Type | Where you find it | Typical symptom when worn |
|---|---|---|
| Single-handle cartridge | One-handle lavatory faucets (for example the Moen 1225 family) | Drip from the spout, stiff handle, poor mixing |
| Ceramic disc cartridge (two-handle) | Quarter-turn handles on many modern faucets | Drip that a new washer will not fix; handle turns past stop |
| Compression stem | Older two-handle faucets with multi-turn handles | Drip from a worn seat washer; usually rebuildable |
| Ball or seats-and-springs | Some single-handle designs | Leak at the base or spout; rebuild kits replace seats and springs |
How to identify yours
- Find the brand on the faucet base, handle, or escutcheon; the model is often on a tag on the supply line or in the paperwork.
- Check the maker’s parts lookup or call their support line; many replace cartridges under warranty.
- If you cannot find a model, remove the old cartridge and bring it to a plumbing supply counter to match length, spline count, and stem style.
- Hard water wears seals and coats cartridges with scale — see softening options if you keep replacing parts.
How replacement usually goes
Follow the faucet maker’s instructions — every model is a little different. The general flow:
- Shut off both angle stops under the sink and open the faucet to relieve pressure — see supply lines and shutoff valves.
- Plug the sink drain so small parts cannot fall in.
- Pop the handle cap, remove the handle screw and handle, then the retaining nut or clip.
- Note the cartridge orientation (take a photo), then pull it straight out. Some need a puller tool.
- Clean the valve body, lightly grease O-rings with plumber’s silicone grease if the maker allows, and install the new cartridge in the same orientation.
- Reassemble, open the stops slowly, and check hot and cold sides for direction and leaks.
If hot and cold are reversed afterward, the cartridge is usually rotated 180°; most makers explain how to correct it.
When to call a plumber
- Angle stops will not shut off, or you have no stops — a licensed plumber should replace them first.
- The faucet body is cracked or the cartridge is seized — often a faucet replacement.
- A tub or shower valve inside the wall — see shower valve types; that is licensed plumber work in most homes.
Getting help
Start with a licensed plumber for shutoff valves, stuck cartridges, and anything in the wall. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates.
Related across the site
- Is my softener working? — scale on new cartridges is a hard-water sign
- Softener plus under-sink RO — treatment that protects faucets and drinking water
Sources
- Faucet manufacturer parts guides and cartridge replacement instructions.
- Model plumbing codes (IPC and UPC) — fixture shutoffs; check your local adopted code.