Sump pumps · maintenance
How to clean a sump pit
Silt, gravel, and debris in a sump pit can clog the pump intake or jam the float, and a jammed float is one of the most common reasons a sump pump fails during a storm. Cleaning the pit once a year, ideally before the spring or fall wet season, takes about an hour.
Bottom line
Unplug the pump before your hands go into the pit, wear gloves, and test the pump afterward. If the pit keeps filling with sand or the pump is old, call a licensed plumber or waterproofing professional rather than just cleaning more often.
Before you start
- Unplug the primary pump and any battery backup. If the pump is hard-wired, turn off the circuit.
- Pick a dry day so the pit is not filling while the pump is out.
- Wear waterproof gloves and eye protection; pit water can be dirty. If your pit is sealed for radon, see radon-sealed covers and reseal afterward.
- If a sewage ejector is in the pit (it takes toilet or laundry waste), stop: that is a plumber job. See the basics on the difference.
Step by step
- Remove the lid and note how the float and discharge are arranged; a phone photo helps.
- Disconnect the discharge at the union or rubber coupling above the check valve. Expect some water to drain back.
- Lift the pump out into a bucket or onto a tarp.
- Remove water and silt from the pit with a wet/dry vac or a utility pump, then scoop out gravel and debris.
- Clean the pump: rinse the intake screen with a garden hose outside, clear the float path, and check the cord for damage.
- Check the check valve for debris and that it closes; replace it if it chatters or leaks back.
- Reinstall the pump level on a solid base (a paver or the pit floor, not loose gravel), with the float free to move.
- Plug in and test by filling the pit with a bucket until the pump cycles; see the test checklist.
Warning signs while you are in there
- Lots of sand or soil each year — the drain tile or pit may be letting in fines. Waterproofing pro.
- Rust, a burnt smell, or a cracked housing on the pump — plan a replacement; see choosing a primary pump.
- A pit with no lid or a cracked liner — see pit liners and lids.
- A float that rubs the pit wall — consider a vertical or electronic switch; see float switches.
Tools that make it easier
- Wet/dry shop vacs (Amazon search, high to low) — fastest way to empty water and silt
- Utility transfer pumps (Amazon search) — empties the pit through a garden hose
- Long-cuff waterproof gloves (Amazon search) — pit water is dirty
- 1½″ sump check valves (Amazon search) — replace a sticky or leaking valve while the pump is out
Getting help
Start with a licensed plumber or waterproofing professional for repeated silt, a failing pump, or a pit that keeps flooding. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — Contact R.E. Merrill & Associates.
Related across the site
- Sump alarms and Wi-Fi monitors
- Battery backup sump pumps
- Basement flood-prep kit
- Septic: what not to drain into the system (sump water should not go to septic)
Sources
- Sump pump manufacturer owner manuals (cleaning and testing sections).
- Local plumbing code on sump discharge.
- Licensed plumber or waterproofing professional for the specific basement.