Well pumps · troubleshooting
Air in water lines on a well: causes and fixes
Sputtering faucets, bursts of air, or milky water that clears from the bottom up are common well complaints. Sometimes it is harmless dissolved air; sometimes it means the pump is drawing the well down, a pipe is leaking, or a tank part has failed. Here is how to narrow it down before you call a licensed well contractor.
Common causes
| Cause | Clues | Who fixes it |
|---|---|---|
| Water level drawn down to the pump intake | Air after long use (irrigation, laundry), sputtering that stops after a rest | Well contractor: check yield, pump depth, and possibly a pump-protection control; see sizing |
| Hole or loose joint in the drop pipe | Air on every cycle, pressure bleeds off, pump short cycles | Well contractor pulls and repairs |
| Leaking check valve or a weep hole | Spurts of air at the start of each draw; pressure falls overnight | Well contractor; see check valves |
| Jet pump suction leak (shallow wells) | Pump loses prime, air every cycle | Plumber or well contractor reseals the suction side; see jet vs submersible |
| Failed pressure-tank bladder or an old air-volume control | Spitting plus rapid on/off cycling, tank sounds waterlogged | See precharge and short cycling |
| Dissolved gas in the groundwater | Milky water that clears from the bottom of the glass up; sometimes odor | Water test first; treatment by a water-treatment pro |
| Air only on the hot side | Cold is fine | Water heater issue, not the well; licensed plumber |
Safe homeowner checks
- Fill a clear glass. Tiny bubbles that clear from the bottom up are usually dissolved air; air bursts with sputtering are a supply problem.
- Note whether the air shows up after heavy use or on every cycle.
- Watch the pressure gauge overnight with no water in use. A slow drop points to a check valve or leak.
- Check the tank precharge with the power off and the tank drained — see how to check it.
- If there is any odor, especially rotten-egg or a fuel smell, ventilate, avoid open flames, and get the water tested; see well water testing and rotten-egg water.
Careful notes
- Some groundwater carries dissolved gases such as methane. If you suspect gas, do not guess: ask your health department and a well contractor about testing and venting.
- Running a pump with no water to pump can damage it. If the well is drawing down, limit use until a contractor checks it.
Parts and references (ancillary only)
We do not sell well pumps on Amazon. For pumps and pump controls, ask REM about Grundfos. These are honest ancillaries:
- Liquid-filled 0–100 psi pressure gauges (Amazon search) — watch for overnight pressure loss
- Digital air gauges (Amazon search) — for checking tank precharge
- Water well handbooks (Amazon search, high to low) — background on drawdown, yield, and drop pipes
Start with a licensed well contractor for air with pressure loss, drawdown, or muddy water. For Grundfos pump options, ask your REM/Grundfos dealer. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates.
Related across the site
- Low water pressure on a well
- SQ vs SQE constant pressure
- Sand and spin-down filters
- Iron and well-water softeners
Sources
- Grundfos residential submersible pump installation and troubleshooting literature.
- U.S. EPA and state private well owner guidance.
- Licensed well contractor for the specific well.