Fixtures · troubleshooting
Water hammer: causes and arrestors
Water hammer is the bang or thud you hear when moving water is stopped suddenly. When a fast-closing valve snaps shut, the water rushing toward it has nowhere to go, and the pressure spike travels back through the pipe. Washing machines, dishwashers, ice makers, and single-lever faucets are the usual triggers. It is more than a noise: repeated shocks can loosen pipe supports and stress hoses, valves, and fittings over time.
Is it water hammer?
| Sound and timing | Likely cause |
|---|---|
| Single loud bang right when a washer, dishwasher, or faucet shuts off | Water hammer |
| Rattling or knocking while water is running | Loose pipe in its straps or rubbing framing; sometimes high velocity |
| Ticking or creaking on hot lines as they warm or cool | Thermal expansion of the pipe, not hammer |
| Banging when the well pump starts or stops | Check valve or pressure issue on the well side; see well check valves |
| Hum or buzz at a toilet while it fills | Worn fill valve; see toilet fill valves and flappers |
1. Check your water pressure
Screw an inexpensive pressure gauge onto an outdoor faucet or the washer cold valve, open it with nothing else running, and read the static pressure. Many plumbing codes call for a pressure-reducing valve (PRV) when street pressure is above 80 psi. If your reading is high, or a PRV you already have is no longer holding a steady setting, have a plumber check or replace it. On a private well, pressure is set by the pump’s pressure switch instead.
2. Recharge old air chambers
Older homes often have short capped pipe stubs, called air chambers, above some valves. Over time the trapped air dissolves and they fill with water, so the hammer returns. To recharge them:
- Close the main water shutoff. See finding the whole-house water shutoff.
- Open the highest faucet in the house and the lowest faucet or hose bib, and let the system drain.
- Close the faucets and slowly reopen the main. Air refills the chambers as the pipes drain and refill.
If the bang comes back within days or weeks, the chambers are not enough on their own; arrestors are the longer-term fix.
3. Add water hammer arrestors
An arrestor is a small sealed cylinder with a piston and an air or gas cushion that absorbs the pressure spike. Unlike an air chamber, it is designed not to waterlog. Look for arrestors tested to ASSE 1010 or PDI-WH 201.
- Place them close to the quick-closing valve, on both hot and cold where the appliance uses both.
- Washing machines: screw-on arrestors fit between the washer valve and the hose. See washing machine hoses.
- Dishwashers, ice makers, and faucets: arrestors often go at the angle stop under the sink. See supply lines and shutoff valves.
- Inside walls or soldered lines: this is plumber work.
4. Secure loose pipe
Pipes that are not held firmly will move and amplify the noise. In an unfinished basement, look for long runs with missing or loose straps and add appropriate pipe clamps or isolators. Use straps rated for the pipe material; avoid mixing copper and steel without isolation.
When to call a plumber
- Static pressure is above what local code allows, or a PRV needs adjusting or replacing.
- Arrestors must be cut into copper, PEX, or galvanized lines, or installed inside walls.
- You see leaks, wet drywall, or loose fittings near where the banging happens.
Call a licensed plumber for pressure-reducing valves, cut-in arrestors, and any work inside walls. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — contact R.E. Merrill & Associates with general water-system questions.
Related across the site
- Softener bypass valves — another valve on the main line
- Well short cycling — banging that comes with frequent pump starts
Sources
- ASSE 1010 and PDI-WH 201 standards for water hammer arrestors (scope and testing).
- Model plumbing codes (IPC and UPC) on maximum static pressure and pressure-reducing valves.
- Washer and dishwasher manufacturer installation manuals; general residential plumbing practice.