Well pumps · troubleshooting
Well pump runs but no water: what it can mean
You hear the pump running, the breaker is on, and yet the faucets give little or nothing. That pattern points to a short list of causes, from a clogged filter you can fix in minutes to a split drop pipe or a dry well. A pump that runs without moving water can overheat, so act quickly.
First checks you can do safely
- Pressure gauge — what does it read with the pump running? Near zero means no water is reaching the tank. See well pressure gauges.
- Valves — is a main or tank valve partly closed after recent work?
- Sediment filter — a plugged cartridge or spin-down screen can choke flow. Bypass it briefly to test.
- Cold weather — a frozen line between the well and the house, or at the tank, stops flow. See well freeze protection.
- Jet pumps — a shallow or deep-well jet pump can lose prime; follow the pump manual to re-prime, and stop if it will not hold.
Likely causes by symptom
| Symptom | Possible cause | Who handles it |
|---|---|---|
| Water at first, then sputtering or air, pump keeps running | Water level drawn down below the pump intake; low-yield well | Well contractor (yield test, pump setting, controls) |
| Pump runs, gauge stays near zero, no recovery after rest | Split drop pipe, separated coupling, or broken pump shaft/coupling | Well contractor (pump pull) |
| Pressure builds slowly, then drops back when the pump stops | Leaking check valve or drop-pipe leak; see check valves | Well contractor |
| Gradual loss of flow over months, sand in water | Worn impellers from sand | Well contractor; consider pump sizing |
| Pump runs nonstop even with good pressure | Stuck pressure switch contacts; see pressure switches | Licensed electrician or well contractor |
| Pump starts and stops repeatedly, pressure won’t build | Pump protection tripping on dry-run or overload | Well contractor |
Why to shut the pump off
Submersible pumps are cooled by the water flowing past them. Running with no water, or against a broken pipe, can damage the motor and impellers. Some constant-pressure pumps, including Grundfos SQ and SQE models, include dry-running protection that stops the pump and restarts later, but that is a safeguard, not a fix. See SQ vs SQE.
What to tell your well contractor
- Pump type (submersible or jet), age, and well depth if you know it.
- What the gauge reads running and resting, and whether water returns after a rest.
- Recent heavy use (irrigation, filling a pool), drought, or recent service.
Honest ancillaries
We do not sell well pumps on Amazon. For pumps and pump controls, ask REM about Grundfos. These are honest ancillaries:
- Liquid-filled 0–100 psi gauges (Amazon search, high to low) — a readable gauge makes every diagnosis faster
- Spin-down sediment filters (Amazon search, high to low) — see sand and clear the screen without changing cartridges
Start with a licensed well contractor when the pump runs without delivering water. For Grundfos pump options, ask your REM/Grundfos dealer. R.E. Merrill & Associates has handled industrial and municipal pumps and fluid systems since 1987 — Contact R.E. Merrill & Associates.
Related across the site
Sources
- Grundfos residential submersible pump installation and troubleshooting literature.
- A licensed well contractor for the specific well and pump.